1 kirjoitettu arvostelu kielellä suomi tuotteesta Anycubic Kobra S1 Combo

Seems decent

Pisteytys 4 /5 tähteä.

Assembly was relatively easy, took about 30min for a first timer. Just remember to remove every screw marked with the red arrows, attach the tubes, plug the data and power cables and remove the paddings.

One of the feet had come off during transport. Seems like they are just glued to the bottom. Fixed by adding a bit of extra glue. It looked like there are screw holes but the manual had no mention if I'm supposed to screw them in place or what.

Camera quality is not great but it does its job. Sometimes the video feed fails to connect and you have to retry. There's a mobile app with the video as well.

Ace pro has problems with certain cardboard spool filaments, ruining my first multicolor print by constantly failing to rotate and tangling the filament, pushing it into the ace pro every time the color was changed. This was fixed by printing pla rims for the spools which would snap in place and make their diameter larger. This seems to be a design flaw of the ace pro, not taking into account the varying spool diameters. I could still resume and finish the print, though the pauses left some visible creases on the print.
Its a minor inconvenience as you may need to find and print new spool rims for any new filament brand if you get unlucky.

Multicolor prints waste a lot of filament and take much longer time, but this seems to be the standard. When watching it switch colors I still can't help but think that its slower than necessary. Still its nice to have 4 colors ready at any time even if just doing single color prints.

Print quality and speed seem decent. I only tried a Prusa mk3s before and this printed the same print in about 1/3 the time on default settings.

Time will tell how well it lasts, but it seemed the main spare parts are cheap and available.

Oliko tästä arvostelusta apua? Kyllä (1) Ei (0)